Installation and Setup
www.nvidia.com
NVIDIA DGX-1 DU-08033-001 _v13.1|16
Ethernet Port Position
Port Designation: Base OS
Software 2.x and earlier
Port Designation: Base OS
Software 3.x and later
Left Side em2 enp1s0f1
NVIDIA recommends connecting only one of the Ethernet ports to your LAN. If
you are connecting both Ethernet ports, they must each be connected to separate
networks, The DGX-1 is not configured from the factory to have multiple Ethernet
interfaces on the same network.
2.
Using an Ethernet cable, connect the IPMI (BMC) port to your LAN for remote
access to the base management controllerr (BMC).
Vefiy that all network cables are firmly inserted into the DGX-1 and the associated
network switch.
2.10.Setting Up the DGX-1
These instructions describe the setup process that occurs the first time the DGX-1 is
powered on after delivery. Be prepared to accept all EULAs and to set up your username
and password.
1.
Connect a display to the VGA connector, and a keyboard to any of the USB ports.
For best display results, use a monitor with a native resolution of 1024x768 or lower.
2.
Power on the DGX-1.
To Next Page
Loading...
Need help?
General
