Oki Data CONFIDENTIAL
44043511TH Rev.2
175 /
5.2.9 Setup of destination
[Checking method: Menu Map Print]
Always set the destination prior to shipping out a printer or maintenance PCB, since the default
setting is OEL.
Note! This setting is stored on the EEPROM of the TBX PCB.
1. Setup on the operation panel: Start the printer in the maintenance mode, and set the
destination.
• Turn on the power with the MENU+ and MENU- key held down.
• "Maintenance Menu" will be displayed briefly, which will change to "OKIUSER".
• Press the MENU+ key to select the destination setting "OKIUSER" and press the
ENTER key.
• "OEL" will appear in the lower line of the LCD.
• Press the ENTER key, select the destination by operating the MENU+ or MENU- key,
and press the ENTER key.
• Press the BACK key to define the setting. "APS"
• Press the BACK key twice, or the ONLINE key once. This will cause the printer to restart
with the destination modified.
2. Explanation
This setting is stored on the EEPROM of the TBX PCB.
When the version number of the program ROM is changed, the setting will be reset to the
default value.
Make this setup when there is no destination set up or the version number of the program
has been changed.
To Next Page
Loading...
Need help?
General
