Omron CJ2-CPU User Manual

6 - 9
6 Installation
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
6-1 Installing Units
6
6-1-4 Installing the EtherNet/IP Coupler Unit
This section describes how to install the EtherNet/IP Coupler Unit.
Precautions for Safe Use
• Always turn OFF the power supply before installing the Unit.
If the power supply is not OFF, the Unit may malfunction or may be damaged.
• Do not apply labels or tape to the Unit. When the Unit is installed or removed, adhesive or
scraps may adhere to the pins in the NX bus connector, which may result in malfunctions.
• Do not touch the pins in the NX bus connector on the Unit. Dirt may adhere to the pins in the
NX bus connector, which may result in malfunctions.
• Do not write on the EtherNet/IP Coupler Unit with ink within the restricted region that is
shown in the following figure. Also do not get this area dirty. When the Unit is installed or
removed, ink or dirt may adhere to the pins in the NX bus connector, which may result in mal-
functions in the EtherNet/IP Slave Terminal.
Precautions for Correct Use
• When you handle the Unit, be careful not to touch or bump the pins in the NX bus connector.
• When you handle the Unit, be careful not to apply stress to the pins in the NX bus connector.
If the Unit is installed and the power supply is turned ON when the pins in the NX bus con-
nector are deformed, contact failure may cause malfunctions.
6-1-4 Installing the EtherNet/IP Coupler Unit
Example: NX Unit (12 mm width)
NG
NG
Restricted region (shaded portion)

Omron CJ2-CPU Specifications

General

Brand	Omron
Model	CJ2-CPU
Category	Controller
Language	English