Omron CJ2-CPU User Manual

A - 67
Appendices
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
A-10 Version Information
A
A-10-1 Relationship between Unit Versions
A-10 Version Information
This section describes the relationship between the unit versions of the EtherNet/IP Coupler Units,
CPU Units, and Industrial PCs and the versions of the Support Software.
This section describes the relationship between the unit versions of the EtherNet/IP Coupler Units,
CPU Units, and Industrial PCs and the versions of the Support Software for different system configura-
tions.
If you use any of the combinations of versions/unit versions that are the same or that are later or higher
than the corresponding versions given in the following table, you can use all of the functions that are
supported by that unit version of the EtherNet/IP Coupler Unit. Refer to A-10-2 Functions That Were
Added or Changed for Each Unit Version on page A-70 for the functions that are supported for each
unit version of the EtherNet/IP Coupler Unit.
Refer to version-related information given in the user’s manuals of the CPU Unit or Industrial PC for
corresponding versions when using CPU Unit versions, Industrial PC unit versions, and Support Soft-
ware versions that are the same or that are later or higher than the corresponding versions.
Depending on the type and model of the Unit, some Units do not have all of the versions given in the
corresponding versions. If a Unit does not have the specified version, support is provided by the oldest
available version after the specified version. Refer to the user’s manuals for the specific Units for the
relation between models and versions.
The following describes the relationship between the unit versions of the EtherNet/IP Coupler Units, the
unit versions of the NJ/NX-series CPU Units, the unit versions of the NY-series Industrial PCs, and the
versions of the Support Software.
 NX-series CPU Unit or NY-series Industrial PC
 NJ-series CPU Unit
A-10-1 Relationship between Unit Versions
Connection to the NJ/NX-series CPU Unit or NY-series Industrial PC
EtherNet/IP Coupler Unit Corresponding unit version/version
Model
Unit ver-
sion
Unit version of
CPU Unit or
Industrial PC
Sysmac Studio
version
Network Config-
urator for Ether-
Net/IP version
CX-Configura-
torFDT version
NX-EIC202 Ver.1.2 Ver.1.14 Ver.1.19 Ver.3.21
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Ver.1.0 Not possible. Not possible. Not possible. Not possible.
EtherNet/IP Coupler Unit Corresponding unit version/version
Model
Unit ver-
sion
Unit version
of CPU Unit
Unit version
of
CJ1W-EIP21
Sysmac Stu-
dio version
Network
Configura-
tor for Eth-
erNet/IP
version
CX-Configu-
ratorFDT
version
NX-EIC202 Ver.1.2 Ver.1.14 Ver.2.1 Ver.1.19 Ver.3.21
Ver.2.4
*1
Ver.1.0 Not possible. Not possible. Not possible. Not possible. Not possible.

Omron CJ2-CPU Specifications

General

Brand	Omron
Model	CJ2-CPU
Category	Controller
Language	English