Omron CJ2-CPU User Manual

A - 69
Appendices
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
A-10 Version Information
A
A-10-1 Relationship between Unit Versions
 CJ2M-CPU3 CPU Unit
The following describes the relationship between the unit versions of the EtherNet/IP Coupler Units, the
unit versions of the Sysmac Gateway, and the versions of the Support Software.
 Sysmac Gateway
EtherNet/IP Coupler Unit Corresponding unit version/version
Model
Unit ver-
sion
Unit version
of CPU Unit
Unit version
of
CJ1W-EIP21
Network
Configura-
tor for Eth-
erNet/IP
version
NX-IO Con-
figurator
version
CX-Configu-
ratorFDT
version
NX-EIC202 Ver.1.2 Ver.1.0 Ver.2.1 Ver.3.21 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Ver.1.0
Ver.1.00
*2
*2. You can connect only to the peripheral USB port on the EtherNet/IP Coupler Unit. You cannot connect with
any other path.
Ver.2.2
Connection to the Sysmac Gateway
EtherNet/IP Coupler Unit Corresponding unit version/version
Model Unit version
Sysmac Gate-
way version
Network Con-
figurator for
EtherNet/IP
version
NX-IO Configu-
rator version
CX-Configura-
torFDT version
NX-EIC202 Ver.1.2 Ver.1.31 Ver.3.50 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port
on the EtherNet/IP Coupler Unit.
Ver.1.0
Ver.1.00
*2
*2. You can connect only to the peripheral USB port on the EtherNet/IP Coupler Unit. You cannot connect with
any other path.
Ver.2.2

Omron CJ2-CPU Specifications

General

Brand	Omron
Model	CJ2-CPU
Category	Controller
Language	English