Omron E5AC-T User Manual

5 - 91
5 Advanced Operations
E5@C-T Digital Temperature Controllers User’s Manual (H185)
5-23 Using the CX-Thermo to Set Programs
5
5-23-1 Introduction
5-23 Using the CX-Thermo to Set
Programs
You can use the programming setting functions of the CX-Thermo to easily and visually set programs.
Use CX-Thermo version 4.61 or higher.
Refer to the following sections for the setting procedures with the keys on the Digital Controller and for
information on the parameters.
• 4-2 Initial Setup Examples through Starting Program Operation on page 4-10
• 4-7 Setting Programs on page 4-27
• 5-15 Program-related Functions on page 5-53
• Section 6 Parameters on page 6-1
Additional Information
The Digital Controller receives the power supply required for setup from the computer through
the USB bus.* You do not have to wire a power supply to the Digital Controller to set programs
with the CX-Thermo or with the keys on the Digital Controller.
*The USB bus power supply is used to display and set parameters. The control outputs will not operate.
5-23-1 Introduction

Omron E5AC-T Specifications

General

Brand	Omron
Model	E5AC-T
Category	Temperature Controller
Language	English