Omron E5AC-T User Manual

3 - 17
3 Part Names and Basic Procedures
E5@C-T Digital Temperature Controllers User’s Manual (H185)
3-4 Procedures after Turning ON the Power Supply
3
3-4-2 Basic Procedure
3 Set the control method.
Standard Models
Position-proportional Models
4 Make the initial program-related settings.
• Program Time Unit (t-u)
• Step Time/Rate of Rise Programming (t-pr)
• Reset Operation (rtsm)
• Operation End Operation (eset)
• Startup Operation (p-on)
Refer to Section 4 Basic Operation for the setting procedures.
Initial Setting Level
Initial Setting Level
Operation Level
Operation Level
The display flashes.
Press the O
(Level) Key for at
least 3 seconds.
in-t (IN-T) will be displayed
to show that the Initial Setting
Level has been entered.
0
25
5
in-t
cntl (CNTL): Indicates the control method.
The default setting is pid (PID control).
Initial Setting Level
PID Control
Press the M (Mode)
Key several times to
display cntl (CNTL).
pid
cntl
Confirm that pid (PID Control) is
displayed.
Close/Floating Control
clfl (CLFL): Indicates either close
or floating control.
Initial Setting Level
Default setting is flot (FLOT: floating control).
flot
clfl
Press M (Mode) Key
several times to display
clfl (CLFL).

Omron E5AC-T Specifications

General

Brand	Omron
Model	E5AC-T
Category	Temperature Controller
Language	English