E5CK
5–23
Remote/Local
Conditions of Use
The communications function must be in
use.
Ă• Switches between remote and local operation.
Ă• To change the parameter setting during remote operation, use the communications
function. To change the parameter setting during local operation, change the setting
on the E5CKĆT controller. You can check the parameter setting by both communicaĆ
tions and on the E5CKĆT controller regardless of whether the controller is switched
to remote or local operation.
Setting Range
Default
“ ”: remote / “ ”: local
ĂRelated description
Chapter 6 Using the Communications Functions
ĂRelated parameters
Communication stop bit" Communication data length" Communication parity"
Communication baud rate" Communication unit No." Event input assignment
1" (option mode)
ĂOption units
E53ĆCK01/03
Standby time
Ă• Sets the time until program operation is started after the run instruction is issued.
Setting Range Unit Default
0.00 to 99.59 Hour, minute 0.00
ĂRelated description
4.6 Setting Running Conditions/Starting the program run/Standby operation (page
4Ć20)
ĂRelated parameter
Standby time monitor" (level 0 mode)
Level 2 Mode
Function
Setting
See
Model
Function
Setting
See
To Next Page
Need help?
General
