CHAPTER 2 PREPARATIONS
E5CK
2–2
2.1 Setup
The following section describes how to draw out the internal mechanism
from the housing and how to set the input type jumper.
Draw out the internal mechanism from the housing.
(1) Press in both of the hooks on the left and right sides of the front panel
to unlock the internal mechanism from the housing.
(2) Draw out the internal mechanism towards you holding both sides of
the front panel.
JSetting the input type jumper
Ă• For details on where the input type jumper is located, see the figure on
page 1-2.
Ă• Set the jumper to one of temperature input, voltage input or current inĆ
put matched to the type of sensor connected to the input terminal.
I : Current input V : Voltage input
TC/PT : Temperature input
Ă• The input type jumper is factory-set to TC/PT (temperature input)".
Ă• When you disconnect or insert the input type jumper, do not hold it diĆ
rectly by its pins.
Ă• When you have finished setting the input type jumper, insert the interĆ
nal mechanism back into the housing.
Ă• To do this, push in the internal mechanism until you hear the hooks on
the front panel snap into place.
JDraw-out
To Next Page
Loading...
Need help?
General
