CHAPTER 5 PARAMETERS
E5CK
5–28
Ă• The parameters in this mode can be used only when the security" parameter (proĆ
tect mode) is set to 0" and 1".
Ă• This mode contains the parameters for checking or setting the basic specifications of
the E5CKĆT controller. These parameters include parameters for specifying the input
type, scaling, output assignments, and direct/reverse operation.
Ă• To select this mode, press the
key for 1 second minimum. The display changes
to the menu display. If you select [
] pressing the and keys, and then press
the
key for 1 second minimum, the controller enters the setup mode.
Ă• To select parameters in this mode, press the
key. To change parameter settings,
use the
or keys.
Ă• The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol Parameter Name Page
Input type 5-29
Scaling upper limit 5-30
Scaling lower limit 5-30
Decimal point 5-30
C/F selection 5-31
Parameter initialize 5-31
Control output 1 assignment 5-32
Control output 2 assignment 5-32
Auxiliary output 1 assignment 5-33
Alarm 1 type 5-34
Alarm 1 open in alarm 5-35
Alarm 2 type 5-34
Alarm 2 open in alarm 5-35
Alarm 3 type 5-34
Alarm 3 open in alarm 5-35
Direct/Reverse operation 5-35
Setup Mode
To Next Page
Loading...
Need help?
General
