CHAPTER 1 INTRODUCTION
E5CK
1–6
The output functions of the E5CKĆT do not operate for five seconds after the
E5CKĆT is turned ON.
The E5CKĆT supports the following five outputs:
Control output 1
Control output 2
Auxiliary output 1
Transfer output
When using control output 1 and 2, set the output unit (sold separately).
Nine output units are available to suit the output circuit configration.
When using transfer output, add on the communication unit (E53ĆAKF).
Ă• The E5CK-T supports the following twelve output functions:
Control output (heat), Control output (cool), Alarms 1 to 3, LBA,
Time Signals 1 and 2, Program End, Stage Output,
Error 1 (input error), Error 2 (A/D converter error)
Ă• Assign these output functions to control output 1, control output 2 and
auxiliary output 1.
Ă• Only control output (heat), control output (cool), alarms 1 to 3 and LBA
can be assigned to control outputs 1 and 2. Only alarms 1 to 3, LBA, error
1 and error 2 can be assigned to auxiliary output 1.
In the example on the previous page, control output (heat)" is assigned
to "control output 1", "alarm 1" is assigned to "control output 2", and
"alarm 2" is assigned to "auxiliary output 1". Accordingly, the configuĆ
ration is such that heating control output is connected to control output
1, and alarm output is connected to control output 2 and auxiliary outĆ
put 1.
Ă• When the control is heating and cooling control, assign "control output
(cool)" to "control output 1" or "control output 2".
Ă• The E5AK-T supports the following four transfer outputs:
Present SP, Process value, Heating side manipulated variable,
Cooling side manipulated variable
Ă• These transfer outputs can be output after being scaled. Setting of an upĆ
per limit value smaller than the lower limit value is allowed, so reverse
scaling can also be carried out.
JOutput
F Output assign-
ments
F Transfer output
To Next Page
Loading...
Need help?
General
