Omron E5GC User Manual

6 - 15
6 Parameters
E5@C Digital Temperature Controllers User’s Manual (H174)
6-3 Operation Level
6
These parameters individually set the alarm value upper and lower limits when a mode for setting the
upper and lower limits is selected for the Alarm 1 to 4 Type parameter (Initial Setting Level).
al1h
Alarm Value Upper Limit 1
Alarm 1 to alarm 4 must be assigned.
The Alarm 1 to 4 Type parameter must be set to 1,
4, or 5.
al2h
Alarm Value Upper Limit 2
al3h
Alarm Value Upper Limit 3
al4h
Alarm Value Upper Limit 4
al1l
Alarm Value Lower Limit 1
al2l
Alarm Value Lower Limit 2
al3l
Alarm Value Lower Limit 3
al4l
Alarm Value Lower Limit 4
• These parameters set the upper and lower limits for alarms 1 to 4.
• During temperature input, the decimal point position depends on the currently selected
sensor, and during analog input it depends on the Decimal Point parameter setting.
 Related Parameters
Input Type (Initial Setting Level): Page 6-43
Scaling Upper Limit, Scaling Lower Limit, and Decimal Point (Initial Setting Level): Page
6-44
Alarm 1 to 4 Type (Initial Setting Level): Page 6-48
Alarm 1 to 4 Hysteresis (Initial Setting Level): Page 6-52
Standby Sequence Reset (Advanced Function Setting Level): Page 6-64
Auxiliary Output 1 to 4 Open in Alarm (Advanced Function Setting Level): Page 6-65
Alarm 1 to 4 Latch (Advanced Function Setting Level): Page 6-71
Function
Setting
Setting range Unit Default
−1999 to 9999 EU 0
See
See

Omron E5GC Specifications

General

Brand	Omron
Model	E5GC
Category	Temperature Controller
Language	English