Omron E5GC User Manual

6 - 75
6 Parameters
E5@C Digital Temperature Controllers User’s Manual (H174)
6-8 Advanced Function Setting Level
6
amad
Auto/Manual Select Addition Control must be set to 2-PID control.
• This parameter sets whether the Auto/Manual Select Addition parameter is to be
displayed.
 Related Parameters
Auto/Manual Switch (Operation Level): Page 6-9
mant
Manual Output Method
Control must be set to 2-PID control.
A Position-proportional Model set to Close Control
with the Direct Setting of Position-proportional MV
parameter set to ON must be used.
If this parameter is set to HOLD when control moves from Automatic Mode to Manual Mode,
the final MV from Automatic Mode will be used as the initial manual MV. If this parameter is
set to INT, the setting of the Manual MV Initial Value parameter will be used as the initial
manual MV.
 Related Parameters
Manual MV Initial Value (Advanced Function Setting Level): 6-76
Function
Setting
Setting range Default
on: Displayed, off: Not displayed Standard Model: off
Position-proportional Model: on
See
See
Function
Setting
Setting range Default
hold: HOLD, init: INIT hold
See
See

Omron E5GC Specifications

General

Brand	Omron
Model	E5GC
Category	Temperature Controller
Language	English