Omron R88D-KN10F-ECT-L User Manual

9 - 39
9 Servo Parameter Objects
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
9-5 Interface Monitor Settings
9
• Set the required time for the Brake Interlock Output (BKIR) to turn OFF after the motor is
de-energized, when servo OFF status is entered while the motor is operating.
• When the servo is turned OFF while the motor is operating, the motor decelerates to reduce speed,
and the Brake Interlock Output (BKIR) turns ON after the set time (set value x 1 ms) has elapsed.
*1 The time TB in above drawing is either the brake timing during operation (i.e., the set value × 1 ms) or the time
taken until it goes below the value set in the Brake Threshold Speed During Operation (3439 hex), whichever is
shorter.
For the operation time, refer to 7-5 Brake Interlock on page 7-15.
• Set the required speed for the Brake Interlock Output (BKIR) to turn OFF after the servo OFF
command is detected while the motor is operating.
For the operation time, refer to 7-5 Brake Interlock on page 7-15.
3438 hex
Brake Timing During Operation
Setting
range
0 to 10,000
Unit
ms
Default
setting
0 Data
attribute
B
Size 2 bytes (INT16) Access RW PDO map Not possible
3439 hex
Brake Threshold Speed During Operation
Setting
range
30 to 3,000
Unit
mm/s
Default
setting
30 Data
attribute
B
Size 2 bytes (INT16) Access RW PDO map Not possible
All
T
B
*1
3438 or 3439 hex set
value or below
(BKIR)
Servo ON/OFF command
Brake interlock
Motor speed
Released Hold
Motor power
is supplied.
Power supply
No power supply
Approx. 1 to 5
All
When the 3438 hex
set value comes earlier
3438 hex
set value
3438 hex
set value
When the 3439 hex set
value comes earlier
Brake
Release (ON)
Brake
Release (ON)
Brake Engage (OFF)
Brake Engage (OFF)
Motor speed
3439 hex set
value
Motor speed
3439 hex set
value

Omron R88D-KN10F-ECT-L Specifications

General

Brand	Omron
Model	R88D-KN10F-ECT-L
Category	Servo Drives
Language	English