Omron R88D-KN10F-ECT-L User Manual

Appendices
A - 14
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
z (e) Example of Servo OFF during Operation in pp
*1 When the servo is turned OFF, a deceleration stop starts and 6061 hex continues to show the same mode as
the mode of operation (pp) specified in 6060 hex.
*2 After the motor stops, No mode assigned is shown by 6061 hex.
Note The operation during the interval from A to B for drive prohibition and main circuit power OFF is the same as
when the servo is turned OFF.
pp
Operation enabled Switched on
No mode assigned
0
0
pp
1
01
0
0
0
1
0/1
*1
0/1
A
*2
B
0/1
0/1
6061 hex
30 mm/s
6060 hex
(VCMP)
(NEAR)
(Target position ignored)
(VLIM)
(DEN)
(Following error)
(Target reached)
(Remote)
6041 hex: Bit 10
6041 hex: Bit 12
6041 hex: Bit 13
4000 hex: Bit 1
4000 hex: Bit 4
4000 hex: Bit 7
4000 hex: Bit 8
Actual speed
Servo ON Servo OFF
PDS state
6041 hex: Bit 9

Omron R88D-KN10F-ECT-L Specifications

General

Brand	Omron
Model	R88D-KN10F-ECT-L
Category	Servo Drives
Language	English