159
Instruction Upgrades and New Instructions Section 3-2
Sequence Output Instructions
SINGLE BIT SET, SETB(532)
SINGLE BIT RESET, RSTB(533)
SINGLE BIT OUTPUT, OUTB(534)
Data Comparison Instructions
AREA RANGE COMPARE, ZCP(088)
DOUBLE AREA RANGE COMPARE, ZCPL(116)
Floating Point Calculation and Conversion Instructions
Floating Point Data Comparison Instructions: =F, <>F, <F, <=F, >F, and >=F (329 to
334)
FLOATING POINT TO ASCII, FSTR(448)
ASCII TO FLOATING POINT, VAL(449)
Double-precision Floating Point Calculation and Conversion Instructions
Double-precision Comparison Instructions: =D, <>D, <D, <=D, >D, and >=D (335 to
340)
DOUBLE FLOATING TO 16-BIT BINARY, FIXD(841)
DOUBLE FLOATING TO 32-BIT BINARY, FIXLD(8420)
16-BIT BINARY TO DOUBLE FLOATING, DBL(843)
32-BIT BINARY TO DOUBLE FLOATING, DBLL(844)
DOUBLE FLOATING-POINT ADD, +D(845)
DOUBLE FLOATING-POINT SUBTRACT, −D(846)
DOUBLE FLOATING-POINT MULTIPLY, *D(847)
DOUBLE FLOATING-POINT DIVIDE, /D(848)
DOUBLE DEGREES TO RADIANS, RADD(849)
DOUBLE RADIANS TO DEGREES, DEGD(850)
DOUBLE SINE, SIND(851)
DOUBLE COSINE, COSD(852)
DOUBLE TANGENT, TAND(853)
DOUBLE ARC SINE, ASIND(854)
DOUBLE ARC COSINE, ACOSD(855)
DOUBLE ARC TANGENT, ATAND(856)
DOUBLE SQUARE ROOT, SQRTD(857)
DOUBLE EXPONENT, EXPD(858)
DOUBLE LOGARITHM, LOGD(859)
DOUBLE EXPONENTIAL POWER, PWRD(860)
Table Data Processing Instructions
STACK SIZE READ, SNUM(638)
STACK DATA READ, SREAD(639)
STACK DATA WRITE, SWRIT(640)
STACK DATA INSERT, SINS(641)
STACK DATA DELETE, SDEL(642)
Data Control Instructions
PID CONTROL WITH AUTOTUNING, PIDAT(191)
Subroutine Instructions
GLOBAL SUBROUTINE CALL, GSBS(750)
GLOBAL SUBROUTINE ENTRY, GSBN(751)
GLOBAL SUBROUTINE RETURN, GRET(752)
I/O Unit Instructions
CPU BUS UNIT I/O REFRESH, DLNK(226)
Other Instructions
SAVE CONDITION FLAGS, CCS(282)
LOAD CONDITION FLAGS, CCL(283)
CONVERT ADDRESS FROM CV, FRMCV(284)
CONVERT ADDRESS TO CV, TOCV(285)
DISABLE PERIPHERAL SERVICING, IOSP(287)
ENABLE PERIPHERAL SERVICING, IORS(288)
To Next Page
Loading...
Need help?
General
