Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 User Manual

733
Table Data Processing Instructions Section 3-17
Description MIN(183) searches the range of memory from R1 to R1+C–1 for the minimum
value in the range and outputs that minimum value to D.
When bit 14 of C+1 has been set to 1, MIN(183) writes the PLC memory
address of the word containing the minimum value to IR00. (If two or more
words within the range contain the minimum value, the address of the first
word containing the minimum value is written to IR00.)
When bit 15 of C+1 has been set to 1, MIN(183) treats the data within the
range as signed binary data.
Note MIN(183) can be processed in the background. Refer to the SYSMAC CS/CJ/
NSJ Series PLC Programming Manual (W394) for details.
Auxiliary Bit Area A000 to A958 A000 to A959 A448 to A959
Timer Area T0000 to T4094 T0000 to T4095
Counter Area C0000 to C4094 C0000 to C4095
DM Area D00000 to
D32766
D00000 to D32767
EM Area without bank E00000 to
E32766
E00000 to E32767
EM Area with bank En_00000 to
En_32766
(n = 0 to C)
En_00000 to En_32767
(n = 0 to C)
Indirect DM/EM
addresses in binary
@ D0000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
Indirect DM/EM
addresses in BCD
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
Constants Specified values
only
---
Data Registers --- DR0 to DR15
Index Registers ---
Indirect addressing
using Index Registers
,IR0 to ,IR15
–2048 to +2047 ,IR0 to –2048 to +2047 ,IR15
DR0 to DR15, IR0 to IR15
,IR0+(++) to ,IR15+(++)
,–(– –)IR0 to, –(– –)IR15
Area C R1 D
R1+(W–1)
R1
C
W
C words
Min. value
PC memory
address

Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Specifications

General

Brand	Omron
Model	SYSMAC CJ - REFERENCE MANUAL 08-2008
Category	Controller
Language	English