3-19
4) Click the OK button to close the Properties dialog box, then OK again (or Print from some
applications) to print the document.
3.6.2. To print a poster (one page on four sheets of paper)
1) Select 2x2 Poster from the Page drop-down list in the Multipage area.
2) Click the OK button to close the Properties dialog box, then OK again (or Print from some
applications) to print the document.
3.6.3. To scale a document
You can scale a page from 25% of its original size to 400% of its original size in one of two
ways:
1) In the Scaling box type the percent size of the original document into the Original box, or
2) Use the slider to change the value.
The default value is 100%. The page will be printed starting from the top right hand corner
according to the size specied.
3.6.4. To create different printing effects
Different printing effects can be created by adjusting the parameters in the Effects area.
The Density box will change the printing density (weight of the characters, lines and dots)
from a range of 1 (being the lightest) to 4 (the heaviest). The value can be changed by using
the up and down arrows or typing a new value into the box. This changes the amount of toner
that is used to print the page. The default is 2.
The Negative Image check box will reverse the printing and the non-printing areas of the
page so that all the areas that would have been printed are blank, and all non-blank areas on
the page are printed. This creates an effect similar to a photograph negative. The default is
unchecked.
The Toner Saver Mode check box uses the least amount of toner while still creating a
readable image. This will save on the amount of toner consumed but it will also result in a
lower print quality. The default is unchecked.
The Mirror check box will rotate the page image 180° along the vertical axis, creating an
effect like looking at the page in a mirror. The default is unchecked.
Note: • When printing multiple pages on one sheet of paper the image of the page will
be reduced in size in order to fit the number of page images you specify on a
single sheet.
Note: • If the document is scaled up beyond 100% page content outside the printable
area will not be printed on the page.
• The scaling setting is available only when 1UP is selected in the Page drop-
down box.
To Next Page
Loading...
Need help?
General