Safety
1 - 1
1 Safety
1.01 Directives
The PFAFF 3117 was built in accordance with the following European regulations:
● EC Machine Directive ( 89/392/EEC, 91/368/EEC, 93/44/EEC, 93/68/EEC )
● Safety of Appliances Law, Machine Ordinance - 9GSGV
● EC Directive „Electromagnetic Compatibility“ ( 89/336/EEC, 92/31/EEC, 93/68/EEC )
● EN 60204-1 Safety of Machines, Electrical Equipping of Industrial Machines: Part 3
● EN 292 Parts 1 and 2: 1991 Safety of Machines ( Basic Terms )
● EN 294 Safety of Machines; safety clearance margins for avoiding dangerous situations
for the upper limbs
● EN 349 Safety of Machines; minimum safety clearances for avoiding the crushing of
bodily parts
● EN 418 Safety of Machines; EMERGENCY STOP devices
● DIN 45635 Measurement of noise levels
In addition to this Instruction Manual, observe also all generally accepted, statutory and
other regulations and legal requirements - also those of the country in which the machine
will be operating - and all valid environmental protection regulations!
The regionally valid regulations of the social insurance society for occupational accidents or
other supervisory organisations are to be strictly adhered to!
1.02 General notes on safety
● This machine may only be operated by adequately trained operators and only after
having completely read and understood the Instruction Manual!
● All Notes on Safety and Instruction Manuals of the motor manufacturer are to be read
before operating the machine!
● The Danger and Safety Instructions on the machine itself are to be followed!
● This machine may only be used for the purpose for which it is intended and may not be
operated without its safety devices. All Safety Regulations relevant to its operation are
to be adhered to.
● When exchanging sewing tools (e.g. needle, presser foot, needle plate, feed dog or
bobbin), when threading the machine, when leaving the machine unattended and during
maintenance work, the machine is to be separated from the power supply by switching
off the On/Off switch or by removing the plug from the mains!
● Everyday maintenance work is only to be carried out by appropriately trained personnel!
● Repairs and special maintenance work may only be carried out by qualified service staff
or appropriately trained personnel!
To Next Page
Loading...
Need help?
General
