Pima FORCE Series Installation Guide

FORCE Series Installation Guide
14 PIMA Electronic Systems
3 System Programming
3.1 Menus and codes
Like all PIMA alarm systems, FORCE has two menus: User, and Technician, each accessed with
its own Master code. In addition, a new Central Monitoring Station (CMS) menu can have a
separate communication settings lock code.
 Master technician code: allows accessing all the technician menus, including all CMSs
menus, as long as no CMS code was set; see next.
 CMS lock code: an optional code for locking the CMS definitions from accessing it using the
Master technician code. This code only allows the technician/CMS to set and access the
CMS communication definitions, including the account ID and the communication paths.
3.1.1 Code setting guidelines
Note the following when setting codes in the FORCE security system:
 All codes, except the Quick Arm code are made of four to six digits
 The Quick Arm code (set by the users) is made of two digits
 A code cannot start with the two digits of the Quick Arm code
 Codes 1234 and 5555 are reserved
3.1.2 Activation codes
Eight codes for activating devices (via relay outputs) by the system users - whether it’s an
electric gate or a floodlight, users can turn them on and off using these 8 codes. Triggering the
relay outputs is done using the Activation Codes 1-8 programmed output types (see Appendix C,
on page 41).
Activation codes are subject to keypad and user partitioning (where relevant).
3.2 Changing the default Master and Technician
codes
To enter the menus for the first time, FORCE’s default technician and user Master codes must be
changed. The default Master technician code is 1234 , and the default Master user code is 5555 .
These two codes are reserved.
Follow the next steps to change the default codes.
1. Connect the alarm system to power and wait for the main screen to be displayed.
2. Press 5555 - the codes’ menu is displayed.
3. Press - the curser moves to the right of the Master Code .
4. Enter a new 4-6 digit code. Write down the code and advice the
system owner to keep it in a safe place.
5. Press to save the code.
6. Press the down arrow to the Tech. Code and press .
7. Enter a new 4-6 digit technician code. Write down the code and advice the system owner to
keep it in a safe place.
8. Press to save the code.
9. Press to exit.

Pima FORCE Series Specifications

General

Brand	Pima
Model	FORCE Series
Category	Security System
Language	English