Pima FORCE Series Installation Guide

FORCE Series Installation Guide
16 PIMA Electronic Systems
4 Peripherals
The Peripherals menu includes the following sub-menus:
1)  Zone Expanders: see below.
2)  Tampers and EOLs: see below.
3) Keypads: set the no. of addressable keypads (ID=1-16; FORCE Lite/32: ID=1-8). Keypad
with ID=0 is not supervised, nor can it be partitioned.
4)  Keypad Settings: see section 4.3, on page 17.
5) Outputs Expanders: set the no. of the relay output expanders.
6)  Wireless Peripherals: see section 4.3, on page 17.
4.1 Zone expanders
System Configuration  Peripherals  Zone Expanders
The Zone Expanders menu includes the following sub-menus:
1) Remote Zone Exp.: set the no. of 8/16 zone expanders.
Each 16-zone expander is programmed as two 8-zone expanders and
occupies 2 consecutive ID numbers. For example, if expander #3 is a
16-zone one, it takes ID numbers 3 and 4 and so expander #4, the next
expander will take ID number 5 (and not 4).
2)  Local Zone Expander: select if the ZEL508 local zone expander is installed.
3)  Zone Doubling: when selected the onboard zone 1-8 inputs can be used as inputs for 8
additional zones; see section 2.3.3, on page 12.
4.2 Tampers and EOLs
System Configuration  Peripherals  Tampers and EOLs
Parameter
Description
 Tamper 1
TMPR1 input is active.
 Tamper 1+EOL
TMPR1 input is EOL supervised, for detecting a short (one EOL).
 Tamper 2
TMPR2 input is active. FORCE Lite/32: unavailable
 Tamper 2+EOL
TMPR2 input is EOL supervised, for detecting a short (one EOL).
 External Siren+EOL
The SIREN Ext./Int. output is EOL supervised, for detecting cut and
short.
 Internal Siren+EOL
 Double EOL
Two EOL resistors are used on all EOL supervised loops.
Resistor 1-2
Enter the resistors values in Ohm. The value entered is multiplied by
100. For example, when using a 2.2kW resistor, set the value to 220 .

Pima FORCE Series Specifications

General

Brand	Pima
Model	FORCE Series
Category	Security System
Language	English