Pima FORCE Series Installation Guide

FORCE Series Installation Guide
4 PIMA Electronic Systems
Safety Instructions. Read Carefully
The FORCE security system has been registered in accordance with EN60950 and its rules.
Among other things, EN60950 requires us to advise you the following information:
 Hazards of fire and electric shock exist in this alarm system. To reduce the risk of fire or
electric shock, do not expose this alarm system to rain or moisture. Pay attention: Telephone
cords could be a good conductor for lightings energy.
 Warning: this equipment has no mains On/Off switch. The plug of the direct plug-in power
supply is intended to serve as the disconnecting device.
 Dangerous high voltages are present inside the control panel’s enclosure. Refer servicing to
qualified personnel only.
 This alarm system should be used with 230VAC/110VAC, 50/60Hz, protected by anti-electric
shock breaker. Use only the power supply provided with this equipment. Use of unauthorized
power supplies may cause damage.
 Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the unit,
immediately consult a qualified service.
 Disposal of used batteries must be made in accordance with local waste recovery and
recycling regulations.
Default Codes
Master: 5555
Installer: 1234
Signs in this guide
Warning
Note
Enter sub-menus, select/deselect, save selection

Menu with sub-menus

Options menu
Return/Back, cancel (except in the Keypad Settings menu)
/
Select/deselect to enable/disable
#/*
Scroll between zones, partitions, users, etc.

Pima FORCE Series Specifications

General

Brand	Pima
Model	FORCE Series
Category	Security System
Language	English