Pima FORCE Installation Guide

Force Security System - Installation Guide
20
Action and alarm keys
Pressing and holding some keys allows the following actions:
Key
Action
1-4
Arming to Home 1-4 modes
5
Display zone status
*
Turn on/off the keypad’s buzzer for all the chime zones
0
Display the service provider, system name and cloud code
Keypad alarms
The users can trigger three different alarms - panic, fire, and medical - by pressing and holding
key combinations on the keypad. When these alarms are triggered, FORCE activates the
programmed responses for such alarms, including triggering the sirens and reporting the CMS
(where relevant) and contacts.
Key
Combination
Alarm
Response
4 + 6
Medical
The same as in Medical zone
7 + 9
Fire
The same as in Fire zone
* + #
Panic
The same as in Panic zone
Keypad settings
Press and hold the keypad settings key to enter the settings
screen. In this screen you set the keypad’s audio visual definitions:
contrast , brightness , keys backlight and the buzzer’s volume .
Each setting is scaled 0-9. Settings are per keypad.
Use the arrow keys to select a parameter, press Esc to save
and exit.
Warning: if you set the volume to 0, no alert will be sounded from the
keypad buzzer, including from chime zones.
2.12.3 Connect the KLT/KLR500 keypads
Follow the next steps to connect the keypads
5
:
1. Insert a flathead screwdriver to the notches on the keypad’s
bottom, press and remove the backplate.
2. Pass the BUS wires through the opening at the backplate.
3. Mount the backplate on a flat surface.
4. Connect the BUS wires.
5. Attach the keypad to the mounted backplate, top side first.
5
The tamper reports over the BUS.

Pima FORCE Specifications

General

Brand	Pima
Model	FORCE
Category	Security System
Language	English