Pima FORCE Installation Guide

Chap. 8: CMS & Communications
35
b. A user un-bypass a zone
c. Bypass Limit time elapses
3. Following are several points regarding the zone restore reporting:
o A zone restore report is generated when an alarmed zone is closed and rearms itself.
When siren time elapses, the zone status is checked and if it has already been closed,
the report is generated.
o If the zone is not set to trigger the sirens, the report is sent as soon as the zone is
closed.
o If a zone had triggered the alarm and was meanwhile closed, the report will be
generated as the alarm system is disarmed.
o In partitioned system, a zone restore report is generated, only when the partition it’s
allocated to, is disarmed.
The Reporting Codes menu includes the following sub-menus:
Parameter
Details
 Zones
For each zone, set codes for the following events: Alarm+Restore,
Fault+Restore, Bypass+Restore . Press # or * to scroll between zones.
 Arm/Disarm-
User
For each user, set event codes for Arming and Disarming . Press # or * to
scroll between users.
 Arm/Disarm-
Other
Set codes for Arming and Disarming events, in any way other than by users.
 Faults
Set event and restore codes for the following events:
1) Power: AC Loss, Low Battery, Power Loss, Detector’s Voltage Failure,
Fuse, Peripheral’s Power Fault .
2) Communication: Communication Fault, Telephone Line Fault, Cellular
Fault, Network Fault .
3) Sirens: External Siren Fault, Internal Siren Fault .
 Alarms and
Others
Set event and restore codes for the following events:
1) Panic and Fire alarms, Technician On-site , Invalid Code, Test.
2)  Tampers: Tamper 1-2 and Peripherals ’ Alarm and Restore codes.
8.1.3 Custom Zones Reports
System Configuration  CMS & Communications  Monitoring Stations  Custom Zones Reports
Set the ContactID (alarm and restore) codes, and SIA’s alarm and restore codes for the custom
zones. Custom zones are based on modified zone types that allow alarm reporting with any
ContactID or SIA code (other than the original zone type - Burglary, Panic, etc.).
Below is a list of more frequently used ContactID and SIA events, which can be used with the
custom zones.
Event
ContactID
SIA
Gas detected
151
GT
Refrigeration
152
ZA
Loss of heat
153
ZA
Water Leakage
154
WA
Low bottled gas level
157
GA
High temp
158
KA

Pima FORCE Specifications

General

Brand	Pima
Model	FORCE
Category	Security System
Language	English