MAINTENANCE
2.28
C
ILL. 3
Reference
Mark on Tank
14. Place shop towels beneath oil filter (E) . Use Oil
Filter Wrench (PV--43527), turn filter
counterclockwise to remove.
E
15. Usingacleandrycloth,cleanfiltersealingsurface
on crankcase.
16. LubricateO-ringon new filter with afilmof engine
oil. Check to make sure the O-ring is in good
condition.
17. Installnewfilterandturnby handuntilfiltergasket
contacts the sealing surface, then turn and
additional 1/2 turn.
Engine Sump Drain Plug - Bottom View
Crankcase Drain
18. Approximately 1 cup of engine oil will remain in
thecrankcase. To drain, removedrain plugfound
on lower right side of crankcase.
NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks or
scratches.
19. Reinstall drain plug.
20. Remove dipstick and fill tankwith 2 quarts (1.9L)
ofPolarisPremium4SyntheticOil(PN2871844).
21. PlacegearselectorinParkandsetparkingbrake.
NOTE: Clamp or pinch off the vent line 2” from theoil
tank as shown below in the Oil Pump Priming
Procedure for the 500 engine.
22. Re-check the oil level on the dipstick and add oil
as necessary to bring the level to the upper mark
on the dipstick.
23. Dispose of used filter and oil properly.
Oil Tank Drain Plug Torque:
14 ft. lbs. (19 Nm)
Crankcase Drain Plug Torque:
14 ft. lbs. (19 Nm)
Oil Filter Torque:
Turn by hand until filter gasket
contacts sealing surface, then
turn an additional 1/2 turn
Oil Filter Wrench:
(PV--43527)
Oil Tank Screen Fitting Torque:
See Step 12
Recommended Engine Oil:
Polaris Premium 4 All Season
Synthetic, 0W--40, (PN 2871281)
Ambient Temperature Range:
-40° Fto120° F
OIL PUMP PRIMING
PROCEDURE
NOTE: This priming procedure must be
performed whenever the oil hose connection
between the oil tank and pump inlet has been
disconnected or if the sump has been allowed to
drain.
1. Clamp or pinch off vent line (A) approximately 2I
from oil tank, between the end of oil tank vent
fitting and the vent line’s pressure relief slit.
To Next Page
Loading...
Need help?
General
