Polaris A09BG50AA User Manual

MAINTENANCE
2.39
CV SHAFT BOOT
INSPECTION
Inspect the cv shaft boots in the front of the ATV for
damage, tears, wear, or leakinggrease. If therubber
boot exhibits any of these symptoms, replace the
boot. Refer toChapter 7 for CV boot replacement, or
have you Polaris dealer replace the boot.
Inspect Boots
CONTROLS
Check contr ols for proper operat ion, pos itioning
and adjus tment .
G Brake control and switch must be
positioned to allow brake lever to
travel throughout entire range
without contacting switch body.
WHEELS
Inspectallwheelsforrunoutor damage. Checkwheel
nuts andensuretheyaretight. Donotovertightenthe
wheel nuts.
WHEEL, HUB, AND SPINDLE
TORQUE T
ABLE
Item Specification
Front Wheel Nuts 27 Ft. Lbs. (27 Nm)
Rear Wheel Nuts 50 Ft. Lbs. (68 Nm)
Front Spindle Nut Refer to procedure listed in
Chapter 7
Rear Hub Retaining Nut 80 Ft. Lbs. (108 Nm)
WHEEL REMOVAL FRONT OR
REAR
1. Stop the engine, place the transmission in gear
and lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a
suitable stand under the footrest frame.
4. Remove the wheel nuts and remove the wheel.
Front Wheel Nuts (4)
27 ft. lbs. (34 Nm)
Front Spindle Nut
See Ch. 7
Front Wheel
Rear Wheel
Rear Wheel Nuts (4)
50 ft. lbs. (68 Nm)
Rear Hub Nut
80 ft. lbs. (108 Nm)
Taper end faces
wheel for install.

Polaris A09BG50AA Specifications

General

Brand	Polaris
Model	A09BG50AA
Category	Offroad Vehicle
Language	English