ENGINE
3.21
CYLINDER HEAD
INSPECTION
(A)
1. Thoroughly clean cylinder head (A) surface to
remove all traces of gasket material and carbon.
CAUTION: Use care not to damage sealing
surface.
CYLINDER HEAD WARPAGE
Cylinder Head Warpage Limit:
.002″ (.05 mm)
1. Lay a straight edge across the surface of the
cylinder head at several different points and
measure warpage by inserting a feeler gauge
between the straight edge and the cylinder head
surface. If warpage exceeds the service limit,
replace the cylinder head.
CYLINDER HEAD
DISASSEMBL
Y
W ARNING: Wear eye protection or a face shield
during cylinder head disassembly and reassembly.
NOTE: Keep all parts in order with respect to their
location in the cylinder head.
A
1. Using a valve spring compressor (A), compress
the valve spring and remove the split keeper.
NOTE: To prevent loss of tension, do not
compress the valve spring more than necessary.
A
2. Remove spring retainer and spring.
NOTE: The valve springs shouldbe positionedwith
the tightly wound coils against the cylinder head on
progressively wound springs (A).
3. Pushvalveout, keepingit inorder forreassembly
in the same guide.
4. Measure free length of spring with a V ernier
caliper . Check spring for squareness. Compare
To Next Page
Loading...
Need help?
General
