4.36
Fuel Systems
DIGITAL WRENCH DIAGNOSTIC
SOFTWARE
Overview
The Digital Wrench diagnostic software allows the technician to
perform the following tests and observations:
• View / clear trouble codes
• Analyze real-time engine data
• Reflash ECU calibration files
• Guided diagnostics
• Create customer service account records
The following components are required to use the Digital
Wrench software:
• PC or laptop with Microsoft Windows operating system
• Digital Wrench software, part number PU-47063
• Smart Link Module, part number PU-47468
• Interface Cable, part number PU-47469
• PC Interface Cable, part number PU-47470
• Smart Link Module Kit (Includes PU-47468,
PU-47469, and PU-47470 in one kit), part number
PU-47471
• M-10 ACE / ECU-Chassis Power-Up Cable, part
number PA-46355
• 12-volt battery
Digital Wrench Connections
The access point for the ECU power-up and Digital Wrench
connectors is located in the front, left-side of the nosepan.
Follow these steps to connect the diagnostic and power-up
cables to the snowmobile:
1. Assemble the Smart Link cables and module as shown in
the illustration.
2. Open the hood and locate the connectors. Remove the
protective cap from the diagnostic connector.
3. Connect the vehicle interface cable to the diagnostic
connector.
4. Using the power-up cable, part number PA-46355, and a
fully charged 12-volt battery, connect the power-up cable
to the ECU connector.
NOTE: To verify the 12-volt battery and power-up
cable are working, connect the cable to the chassis
power-up connector. If working correctly, the
headlights should illuminate.
DIGITAL WRENCH
CONNECTOR
ECU POWER-UP
(3-WIRE CONNECTOR)
CHASSIS POWER-UP
(2- WIRE CONNECTOR)
To Next Page
Loading...
Need help?
General
