3.6
Maintenance
Torque Stop Adjustment
Set torque stop bumper gap to specification after aligning drive
and driven clutches.
After setting gap, torque jam nut to specification.
NOTE: Where applicable, when installing a new
torque stop, position bumper so the tip is just
touching crankcase.
Engine Isolator Limiter Setting
Some models use an engine mount strap isolator. The isolator is
located on left-front corner of the bulkhead. The isolator should
not make contact with the engine strap.
If the isolator requires adjustment or replacement, hold the
isolator so it is against the bracket, then torque the nut to
specification.
NOTE: Do not adjust this engine isolator limiter as a
torque stop or damage may occur. The approximate
distance from the face of the isolator to the face of
the engine strap is 0.107" (2.72mm).
= In. / mm.
Torque Stop Bumper-to-Engine Gap
.010 - .030 (.25 - .75mm)
= T
Torque Stop Jam Nut: 15-17 ft-lb. (21-24 Nm)
GAP
= T
Jam Nut: 15-17 ft-lb. (21-24 Nm)
ISOLATOR AGAINST BRACKET
BRACKET
NUT
ISOLATOR
To Next Page
Loading...
Need help?
General
