8.35
Steering and Suspensions
8
IQ RMK 144 / 155 / 163 Front / Rear Torque
Arms
Assembly Notes
• Never re-use Nylock nuts. Always replace with new
parts.
• All pivots must rotate freely after tightening fasteners.
• Apply Polaris Premium All Season Grease to all grease
zerks as outlined in the periodic maintenance table.
FRONT TORQUE ARM
SHOCK ASSEMBLY
LIMITER STRAPS
UPPER SHAFT
SHOCK ASSEMBLY
SHOCK ROD
REAR TORQUE ARM
REAR PIVOT (SCISSOR)
SHAFT
ADJUSTER
SLEEVE
SPRING
CARRIER WHEEL
SPACER / SET SCREW
LOWER SHAFT
SHAFT
A
B
B
B
D
D
E
B
C
C
= T
A = 12 Ft.Lb. (16 Nm)
B = 19 Ft.Lb. (26 Nm)
C = 45 Ft.Lb. (61 Nm)
D = 35 Ft.Lb. (47 Nm)
E = 25 Ft.Lb. (34 Nm)
CAUTION
The fasteners securing the rear suspension to the
tunnel are pre-coated with a locking agent when new.
Never re-use these fasteners when removed. Always
use new pre-coated fasteners when mounting the
suspension to the tunnel.
To Next Page
Loading...
Need help?
General
