4.12
Fuel Systems
9. Inspect e-rings, plate, spring, and rings (14) connecting the
slide to the lever if needed.
10. Remove water trap/drain plug (15) and single screw (16)
on the bottom of the carburetor.
11. Remove and drain the float bowl (17).
NOTE: Float bowl will not come off unless the water
trap/drain plug and screw are removed.
12. Remove the two screws (18) holding the float/needle and
seat assembly (19) in position and remove this assembly.
13. Inspect the contents for wear and debris.
14. Remove and inspect the main jet (20), pilot jet (21), and
starter jet (22). Clean them out.
15. Remove the air jet screw if so equipped.
16. Clean out all passages in carburetor body with carburetor
cleaner. Dry all passages and jets with compressed air.
17. Replace gaskets and any parts that show wear or damage.
18. Repeat steps 1-18 for disassembly for the other carburetor
if needed.
14
15
16
17
18
19
20
22
21
To Next Page
Loading...
Need help?
General
