98
TYPE 100/300 Operation and Installation Handbook
5.10 Manual Override (Stern Drive Actuators only)
Manual override should be selected in calibration only on installations
fitted with the stern drive actuator. When it has been selected, the
autopilot can be overridden to allow hand steering by turning the steering
wheel. This will return the autopilot to Standby and sound the control unit
buzzer for 10 seconds. There is a slight delay before the autopilot will
return to Standby.
CAUTION: Excessive force is not required and will not reduce this delay.
With the autopilot in Auto and clear of obstruction, turn the steering wheel
to observe the manual override. Repeat two or three times until you are
confident with its operation.
The manual override is intended for emergency use only. The autopilot
should normally be disengaged by pushing the STANDBY button on the
control unit.
To Next Page
Loading...
Need help?
General
