Optional Car Cord Adapter
The optional DCC08 car cord shown on
page 66 allows you to power your
camcorder from the cigarette lighter
socket of a car, truck, or RV. It converts
12-volts to a 6-volt output.
Note: Consult the installation and operating
instructions enclosed with the DCC08 for
complete operating instructions.
Cautions: The DCC08 is designed to
be used only with vehicles having
negative ground electrical systems.
Use only car cord adapter DCC08 with
this camcorder. Use of any other car
cord adapter may damage the
camcorder and void your warranty.
Using the DCC08 Car Cord Adapter _'_ _ .........
Cigarette
Lighter Socket POWER Indicator
"_'____....__ __ [Power __._"'_¢J / _'------__.
Optional DCC08 Car Cord Adapter
I. Place the POWER switch in OFF to
turn off the camcorder. Power
indicator on the camcorder turns off.
2. If the battery or DC cable is attached
to the camcorder, remove it.
3. Hold the top of the power connector
flush against the camcorder, and press
the bottom of the power connector
down until it locks into place.
4. Take the vehicle's cigarette lighter out
of the socket.
5. Insert the car cord's cigarette lighter
plug into the vehicle's cigarette lighter
socket. The power indicator on the
car cord adapter will light.
6. Place the POWER switch in CAMERA
to turn on the camcorder. The power
indicator on the camcorder lights.
16
To Next Page
Loading...
Need help?
General
