Time-Remaining Display
The approximate time remaining on the tape in the camcorder for the tape speed
you have selected is automatically displayed in the viewfinder. Use the
T20.30o40 button to set the correct tape length before the camcorder can
correctly calculate time remaining.
T20e30_it0
Button
SP-SLP
Button
30MIN I
30MIN
29MIN SP
i
3MIN
l
2MIN
(Flashing)
l
1MIN
(Flashing)
l
OMIN
(Flashing)
T30
TAPE END
Set the Tape Length
1. Use the SP-SLP switch to select the
tape speed. SP or SLP appears in the
viewfinder.
2. Use the To20.30.40 button to select
the length of tape you are using.
• Select 720 if you are using a tape
with 20 minutes or less
recording time.
• Select T30 if you are using a tape
with 30 minutes recording time.
• Select T40 if you are using a tape
with 40 minutes recording time.
The time-remaining indicator will start
flashing when the remaining tape time
reaches two minutes.
TAPE END appears when the tape
reaches its end during recording or a
cassette is loaded whose tape is
already at its end.
52
• :>. .- . .:.:.: : • . :
To Next Page
Loading...
Need help?
General
