Date/Time Display m Setting the Time and Date
The date and time must be set before it can be displayed and recorded on
your tapes. The clock cell must be installed as shown on the previous page
before the date can be set and recorded.
AE Dial
Button
.
I. Make sure the AE dial is not set to
AUTO.
2. Press the MENU button. The
recording menu will appear in the
viewfinder.
3. Press + or - in the center of the AE
dial to highlight DATE/TIME.
GAIN UP MAX
TELE MACRO OFF
INTERVAL TIMER OFF
REC TIME OFF
JLIP ID NO. 07
SET CHARACTER
END :MENU KEY
i
Press • in the center of the AE dial to
display the time and date screen.
5. Press < or • to select the item you
want to set (month, day, year, hour
including AM/PM, and minutes).
6. Press + or- until the correct setting
appears. Press + to go forward or - to
go back.
7. When you are finished, press < or •
to highlight SET.
8. When SETbegins to flash, press
MENU. The menu reappears. Press
MENU again to close the menu.
Notes:
If you enter an invalid date, INPUT ERROR
appears in the viewfinder. Press +, -, <, or P-
and enter the correct day.
To returnto the previous setting while you are
setting the time and date, highlight CANCEL
and pressMENU.
-, I /
JAN 1.00 AM 12:00
/ I \
SET
CANCEL
39
To Next Page
Loading...
Need help?
General
