Renesas M16C/29 Series User Manual

11. DMAC
puorG92/C61M
page 92
854fo7002,03.raM21.1.veR
2110-1010B90JER
Item Specification
No. of channels 2 (cycle steal method)
Transfer memory space • From any address in the 1M bytes space to a fixed address
• From a fixed address to any address in the 1M bytes space
• From a fixed address to a fixed address
Maximum No. of bytes transferred 128K bytes (with 16-bit transfers) or 64K bytes (with 8-bit transfers)
DMA request factors
(1, 2)
________ ________
Falling edge of INT0 or INT1
________ ________
Both edge of INT0 or INT1
Timer A0 to timer A4 interrupt requests
Timer B0 to timer B2 interrupt requests
UART0 transfer, UART0 reception interrupt requests
UART1 transfer, UART1 reception interrupt requests
UART2 transfer, UART2 reception interrupt requests
SI/O3, SI/O4 interrupt requests
A/D conversion interrupt requests
Timer S(IC/OC) requests
Software triggers
Channel priority DMA0 > DMA1 (DMA0 takes precedence)
Transfer unit 8 bits or 16 bits
Transfer address direction forward or fixed (The source and destination addresses cannot both be
in the forward direction)
Transfer mode Single transfer Transfer is completed when the DMAi transfer counter (i = 0,1)
underflows after reaching the terminal count
Repeat transfer When the DMAi transfer counter underflows, it is reloaded with the value
of the DMAi transfer counter reload register and a DMA transfer is con
tinued with it
DMA interrupt request generation timing When the DMAi transfer counter underflowed
DMA startup Data transfer is initiated each time a DMA request is generated when
the DMAE bit in the DMAiCON register = 1 (enabled)
DMA shutdown Single transfer • When the DMAE bit is set to 0 (disabled)
• After the DMAi transfer counter underflows
Repeat transfer When the DMAE bit is set to 0 (disabled)
When a data transfer is started after setting the DMAE bit to 1 (en
abled), the forward address pointer is reloaded with the value of the
SARi or the DARi pointer whichever is specified to be in the forward
direction and the DMAi transfer counter is reloaded with the value of the
DMAi transfer counter reload register
Table 11.1 DMAC Specifications
NOTES:
1. DMA transfer is not effective to any interrupt. DMA transfer is affected neither by the I flag nor by the
interrupt control register.
2. The selectable causes of DMA requests differ with each channel.
3. Make sure that no DMAC-related registers (addresses 002016 to 003F16) are accessed by the DMAC.
Reload timing for forward ad-
dress pointer and transfer
counter

Renesas M16C/29 Series Specifications

General

Brand	Renesas
Model	M16C/29 Series
Category	Microcontrollers
Language	English