If the proof tray exit sensor or the bin exit sensor is actuated when the sorter
stapler unit or the front door is opened and closed, or when the main switch
is turned on, a sorter jam signal is sent to the copier.
Sorter jam conditions are reset by opening and closing the sorter stapler unit
or the front door after clearing the jammed paper.
When an abnormal condition of the main motor, bin lift motor, or jogger
motor is detected for the first time, the copier’s operation panel will indicate a
sorter jam. When the abnormal condition is detected for the second time, the
S/S CPU sends an error signal to the copier. The copier’s operation panel
will indicate a service call code.
10.2 STAPLER ERROR
The sorter stapler main control board detects a stapler error when the
following conditions are detected. The copier’s operation panel will indicate a
sorter jam, and stapling will stop in these cases.
•
If the paper sensor is actuated when the sorter stapler or the front
door is opened or closed, or when the main switch is turned on.
•
If the paper sensor is actuated when the grip assembly returns to
the home position after the stapling operation.
•
The first time an abnormal condition of the stapler motor or grip
motor is detected.
The second time an abnormal condition is detected, the copier’s
operation panel will indicate a service call code.
Sorter Stapler
A554
STM 6-25 A156/A160/A162
To Next Page
Loading...
Need help?
General
