Interface Interface set
ether Ethernet interface
wlan IEEE 802.11 interface
Deleting the Domain Name
msh> domainname “interface_name” clear name
etherauth
Use the "etherauth" command to display or modify the authentication related parameters for Ethernet.
View settings
msh> etherauth
802.1x Configuration
msh> etherauth 8021x {on|off}
• {on} means "active" and {off} means "inactive".
etherconfig
Use the "etherconfig" command to view and configure the Ethernet parameters.
View settings
msh> etherconfig
Specify Ethernet speed
msh> etherconfig speed {auto|10f|10h|100f|100h}
• auto = Auto Select
• 10f = 10 Mbps Full Duplex
• 10h = 10 Mbps Half Duplex
• 100f = 100 Mbps Full Duplex
• 100h = 100 Mbps Half Duplex
• The default is "auto".
help
Use the “help” command to display the available command list and the procedures for using those
commands.
4. Monitoring and Configuring the Printer
168
To Next Page
Loading...
Need help?
General
