Timer Settings
This section describes the user tools in the Timer Settings menu under System Settings.
Auto Off Timer
After a specified period has passed, following job completion, the machine automatically turns off,
in order to conserve energy. This function is called "Auto Off".
The machine status after the Auto Off operation is referred to as "Off mode", or "Sleep mode".
For the Auto Off Timer, specify the time to elapse before Auto Off.
The time can be set from 1 to 240 minutes, using the number keys.
The default setting is “1” min.
Auto Off may not work when error messages appear.
Energy Saver Timer
The machine automatically enters Low Power mode automatically after a job is finished, and the
selected time elapsed.
The time can be set from 1 to 240 minutes, using the number keys.
The default setting is “15” min.
Energy Saver may not work when error messages appear.
The machine automatically prints any fax or printer data received while in Energy Saver mode.
System Auto Reset Timer
The System Reset setting automatically switches the screen to that of the function set in Function Priority
when no operations are in progress, or when an interrupted job is cleared. This setting determines the
system reset interval.
The time can be set from 10 to 999 seconds, using the number keys.
The default setting is [On], “60” sec.
Copier Auto Reset Timer (copier)
Specifies the time to elapse before copier modes reset.
If [Off] is selected, the machine does not automatically switch to the user code entry screen.
The time can be set from 10 to 999 seconds, using the number keys.
The default setting is [On], “60” sec.
Facsimile Auto Reset Timer (facsimile)
Specify the time to elapse before the facsimile mode resets.
The time can be set from 30 to 999 seconds, using the number keys.
The default setting is “30” sec.
1. System Settings
26
To Next Page
Loading...
Need help?
General
