To Next Page

To Previous Page

Using Utilities to Make Network Settings

This section describes how to make network settings using utilities.

You can also specify network settings using utilities such as Web Image Monitor, SmartDeviceMonitor for

Admin, and telnet.

• These settings should be made by the system administrator, or with the advice of the system

administrator.

• For details about using Web Image Monitor, see "Using Web Image Monitor".

• For details about using SmartDeviceMonitor for Admin, see "Using SmartDeviceMonitor for Admin".

• For details about using telnet, see "Using telnet".

• p.117 "Using Web Image Monitor"

• p.131 "Using SmartDeviceMonitor for Admin"

• p.156 "Remote Maintenance by telnet"

Interface Settings

This section describes how to make Interface settings using utilities.

Change settings by using Web Image Monitor, SmartDeviceMonitor for Admin, and telnet.

[Network] [Machine IPv4 Address] [Auto-Obtain (DHCP)]

• Web Image Monitor: Can be used for specifying the setting.

• SmartDeviceMonitor for Admin: Can be used for specifying the setting.

• telnet: Can be used for specifying the setting.

[Network] [Machine IPv4 Address] [Specify] "IPv4 Address"

• Web Image Monitor: Can be used for specifying the setting.

• SmartDeviceMonitor for Admin: Can be used for specifying the setting.

• telnet: Can be used for specifying the setting.

[Network] [Machine IPv4 Address] [Specify] "Subnet Mask"

• Web Image Monitor: Can be used for specifying the setting.

• SmartDeviceMonitor for Admin: Can be used for specifying the setting.

• telnet: Can be used for specifying the setting.

[Network] [IPv4 Gateway Address]

• Web Image Monitor: Can be used for specifying the setting.

2. Connecting the Machine

Ricoh LD220F User Manual

Questions and Answers: