Ricoh LD220F User Manual

• WPA
• Encryption Method
Select either [TKIP] or [CCMP (AES)].
• Authentication Method
Select either [WPA-PSK], [WPA], [WPA2-PSK], or [WPA2].
If you selected [WPA-PSK] or [WPA2-PSK], enter the pre-shared key (PSK) of 8- 63
characters in ASCII code.
When [WPA] or [WPA2] are selected, authentication settings and certificate installation
settings are required. For details about setting methods, see "Configuring IEEE 802.1X".
Wireless LAN Signal
When using in infrastructure mode, you can check the machine's radio wave status using the control
panel.
Radio wave status is displayed when you press [Wireless LAN Signal].
Restore Defaults
You can return the wireless LAN settings to their defaults.
• p.18 "Accessing User Tools"
• p.373 "Configuring IEEE 802.1X"
Print I/F Settings List
This section describes how to print the configuration page.
You can check items related to the network environment.
The configuration page shows the current network settings and network information.
1. Press the [User Tools/Counter] key.
2. Select [System Settings] using [ ] or [ ], and then press the [OK] key.
1. System Settings
34
1

Ricoh LD220F Specifications

General

Brand	Ricoh
Model	LD220F
Category	All in One Printer
Language	English