Enabling/disabling a specified IPv6 destination
msh> route active6 “destination” “prefixlen[1-128]” {on|off}
Route initialization
msh> route flush
• The maximum number of IPv4 routing tables is 16.
• The maximum number of IPv6 routing tables is 2.
• Set a gateway address when communicating with devices on an external network.
• The same gateway address is shared by all interfaces.
• “Prefixlen” is a number between 1 and 128.
set
Use the “set” command to set the protocol information display “active” or “inactive”.
View settings
The following command displays protocol information (active/inactive).
msh> set ipv4
msh> set ipv6
msh> set ipsec
msh> set appletalk
msh> set netware
msh> set smb
msh> set protocol
• When protocol is specified, information about TCP/IP, AppleTalk, NetWare and SMB appears.
msh> set lpr
msh> set lpr6
msh> set ftp
msh> set ftp6
msh> set rsh
msh> set rsh6
msh> set diprint
msh> set diprint6
msh> set web
Remote Maintenance by telnet
177
To Next Page
Loading...
Need help?
General
