SSH/SFTP communication login timeout setting
msh> ssh logintimeout [0-65535]
• The default is 300.
Setting an open key for SSH/SFTP
msh> ssh genkey {512|768|1024} “character string”
• Create an open key for SSH/SFTP communication.
• Usable characters are ASCII 0x20-0x7e (32 bytes) other than "0".
• The default key length is 1024, and the character string is blank.
• If you do not specify this parameter, an open key with the default value will be created.
Deleting open key for ssh/sftp communication
msh> ssh delkey
• If you do not specify a character string, current setting is displayed.
• ssh can be used only with sftp.
status
Use the “status” command to display the printer status.
View messages
msh> status
• p.196 "Getting Printer Information over the Network"
syslog
Use the “syslog” command to display the information stored in the printer's system log.
View message
msh> syslog
• p.216 "Message List"
upnp
Use the “upnp” command to display and configure the universal plug and play.
Remote Maintenance by telnet
187
To Next Page
Loading...
Need help?
General
