Working group name settings
msh> smb group “work group name”
• Set workgroup name using up to 15 characters.
Comment settings
msh> smb comment “comment”
• Set comment using up to 31 characters.
Notify print job completion
msh> smb notif {on|off}
• To notify print job completion, specify “on”. Otherwise, specify “off”.
Deleting computer name
msh> smb clear comp
Deleting group name
msh> smb clear group
Deleting comment
msh> smb clear comment
View protocol
msh> smb protocol
snmp
Use the “snmp” command to display and edit SNMP configuration settings such as the community name.
View settings
msh> snmp
• Default access settings 1 is as follows:
Community name:public
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-only
Effective Protocol:IPv4/IPv6/IPX
• Default access settings 2 is as follows:
Community name:admin
IPv4 address:0.0.0.0
IPv6 address:::
Remote Maintenance by telnet
181
To Next Page
Loading...
Need help?
General
