Ricoh Ri 2000 User Manual

1. Before You Begin RICOH Ri 2000 User Manual
49
1.6. Printer Setup
The setting of IP address for the machine
The setting method of IP address for this machine are two patterns.
Case1: For connecting directly to the printer from a PC that is not parts of a network.
Case2: For DHCP setup
Case1: For connecting directly to the printer from a PC that is not parts of a network.
[Confirming IP address of your PC]
Open the command prompt dialogue box on your PC.
Type “ipconfig” in the first line in the command prompt.
In the “Ethernet adapter Ethernet” section, check the address of “IPv4 Address”,
“Subnet Mask”, and “Default Gateway”. For the IP address, use the “IPv4
Address” but change the last three digits to a number that will be unique to the
printer. For subnet mask and default gateway, use them for the printer.
In the example below, we took 192.168.0.2 and will assign 192.168.0.3 to the printer.
Proceed to Step 1 in [Configuring the IP address of the machine].

Ricoh Ri 2000 Specifications

General

Brand	Ricoh
Model	Ri 2000
Category	Printer
Language	English