Chapter 20 System Utility Function Setting RIGOL
MSO8000 User Guide 20-7
System-related
Beeper
When the beeper is enabled, you can hear the sound of the beeper when you
perform the following operations:
âš« Press a key or a menu key on the front panel
âš« Enable the touch screen
âš« When a prompt message is displayed
Press Utility and then press Beeper continuously to select "ON" ( ) or "OFF" ( ).
By default, it is OFF.
Language
This oscilloscope supports menus in multiple languages. Both Chinese and English
are available for the display of the help information, prompt messages, and interface.
Press Utility → Language and rotate the multi-function knob to select the
desired language; then, press down the knob to select the language. You can
also press Language continuously to select the language or enable the touch screen
to tap the desired language and select it.
Besides, in the help system menu, you can also set the language. Enable the touch
screen and then tap the function navigation icon at the lower-left corner of the
screen to open the function navigation. Then, tap the "Help" icon to open the help
system menu at the right section of the screen. Press Language to set the
language.
System Information
Press Utility → System → About to view the system information of the
oscilloscope, including the manufacturer, product model, serial number, etc.
You can also view the system information of the oscilloscope in the "Help" system
menu.
Power On
You can set the system configuration to be recalled when the oscilloscope is powered
To Next Page
Loading...
Need help?
General
