Publication 2711P-UM001D-EN-P - September 2005
Terminal Connections 6-21
NAP and Redundant Cables
Refer to the ControlNet Cable System Planning and Installation manual
(Publication 1786-6.2.1) for descriptions of ControlNet components.
For information on purchasing these items, refer to the Allen-Bradley
ControlNet Cable System Component List (Publication AG-2.2).
Connect the Module to the Network
You can connect the ControlNet Module:
• directly to a ControlNet network, which requires a tap
• to a device already connected to the ControlNet network
Item Catalog Number
RG-6 quad-shield 1786-RG6
Coax repeater 1786-RPT, -RPTD
Coax taps 1786-TPR, -TPS, -TPYR, -TPYS
Network access cable 1786-CP
Coax tool kit 1786-CTK
Segment terminators 1786-XT
BNC connectors 1786-BNC, -BNCJ, -BNCP, -BNCJ1
IMPORTANT
Do not connect to a network using both the
redundant cable BNC connector and the Network
Access Port (NAP).
WARNING
When used in a Class I, Division 2, hazardous
location, this equipment must be mounted in a
suitable enclosure with proper wiring that complies
with the governing electrical codes.
Do not connect or disconnect any communication
cable with power applied to this device or any
device on the network. An electrical arc could
cause an explosion in hazardous location
installations. Be sure that power is removed or the
area is nonhazardous before proceeding.
To Next Page
Loading...
Need help?
General
