122
Using effects
Editing the effect parameters
You can edit the current effect settings to create your own effect settings.
1.
Perform steps 1~2 of
Switching the effects on/off
(p. 120).
2.
Press
(Edit).
3.
Use to move the cursor to the parameter you want to edit, and use
the VALUE dial or / to edit the value.
The effect setting will change.
Current
effect
Screen that appears
MFX
MFX EDIT screen (p. 375)
Dly/Cho DELAY/CHORUS EDIT screen (p. 375)
Reverb REVERB EDIT screen (p. 375)
Editing separate blocks of an MFX
If you've selected MFX as the current effect, the algorithm is a combination of
several types of effects. You can edit each of these effects (effect blocks) separately.
1.
Access the MFX EDIT screen as described in Editing the effect
parameters (p. 122).
2. Use (Block▲)/ (Block▼) to select the effect block you want
to edit.
The tabs at the left edge of the screen show the effect block highlighted.
3. Use to move the cursor to a parameter, and turn the VALUE
dial or use / to edit the value.
The effect setting will change.
ECS05_manual_e.book 122 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
Need help?
General
