Roland MV-8000 User Manual

364
SAMPLING
QUICK ASSIGN (PATCH:DIVIDE) screen
When you set the Auto Divide parameter to On, here
you can assign the divided sampled data to a partial
of a patch.
To access this screen
• ➜ ➜ (Set the Auto Divide parameter
to On) ➜ (start sampling) ➜ (stop
sampling) ➜
Explanation of each area
1. Sample Name
Displays the name of the sample.
2. Sample Channel
Displays the number of channel of the sample
(Mono/Stereo).
3. Wave window
Displays the beginning of the divided sampled data
(waveform).
4. Pads
Indicates the state of the pads in the current pad
bank.
5. Part
Specifies the instrument part to which you want to
assign the sampled data.
Range: 1 ~16
6. Assign To Pad Bank
Specifies the partial (note number) within the
instrument part selected by Part to which the sample
data will be assigned.
Range: 1 ~6
F-buttons
Name
Displays the EDIT NAME popup (p. 199), where you
can edit the pad name.
Set All
Assigns the sample to the pad number 1 of the
specified pad banks.
When assigning samples, a confirmation message
will appear if a pad to which a sample is already
assigned would be overwritten.
If the waveform was not divided even though Auto
Divide was on, [F4 (Preview)] (p. 363) will be
displayed.
EXIT
Returns to the SAMPLING / RE-SAMPLING screen
(p. 355) without assigning the sample data to a pad.
Indicate
Status
A partial is assigned to the pad.
Nothing is assigned.
A partial will assign to the enclosed pad.
ECS05_manual_e.book 364 ページ ２００５年１１月３０日 水曜日 午前１１時１４分

Roland MV-8000 Specifications

General

Brand	Roland
Model	MV-8000
Category	Music Equipment
Language	English