Roland MV-8000 User Manual

215
SEQUENCE
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
METRONOME popup
Here you can make metronome settings.
To access this screen
• ➜➜
• ➜➜
Explanation of each area
1. Mode (Metronome Mode)
Specifies when the metronome signal will be output.
2. Output (Metronome Output)
Specifies the output destination for the metronome
signal.
3. Level
Specifies the volume of the metronome.
Range: 1~ 100 ~127
The Metronome Level parameter is valid only when
Metronome Output is set to Click or Beep.
4. Accent Note
Specifies the note number for the strong beat (first
beat).
Range: C-1~ C4 ~G9
5. Accent Velocity
Specifies the velocity for the strong beat (first beat).
The Accent Note will be output with the specified
velocity.
Range: 1~ 100 ~127
6. Normal Note
Specifies the note number for the weak beats (other
than the first beat).
Range: C-1~ C3 ~G9
When using the metronome to play a drum set, you
can select a desired percussion instrument by
specifying the note number.
7. Normal Velocity
Specifies the velocity for the weak beats (other than
the first beat). The Normal Note will be output with
the specified velocity.
Range: 1~ 60 ~127
F-buttons
Close
Closes the METRONOME popup.
Value
Explanation
Off The metronome will not sound.
Rec Only
The metronome will sound only during
recording.
Play&Rec
The metronome will sound during play-
back and recording.
Always The metronome will always sound.
Value
Explanation
Click
Output the internal metro-
nome sound (click).
[Beep]
Output the internal metro-
nome sound (beep).
Part 1-16
Use an instrument part to
sound the metronome.
MIDI A-1~A-16
Transmit a note message
from MIDI OUT A.
MIDI B-1~B-16
Transmit a note message
from MIDI OUT B.
MIDI R-1~R-16
Transmit a note message
from R-BUS.
ECS05_manual_e.book 215 ページ ２００５年１１月３０日 水曜日 午前１１時１４分

Roland MV-8000 Specifications

General

Brand	Roland
Model	MV-8000
Category	Music Equipment
Language	English